Yes, the gates require either a direct bury bollard or a surface mount bollard. Surface mount is typically used on a concrete foundation/base while direct bury is generally used when a solid, concrete base is not available. Contact the Safety Source if you are unsure about which bollard you need.
Two bollards are not required, but you can use a second optional bollard as a stopper for the gate.
Direct bury is recommended for installations requiring long-term durability, protection from environmental factors, and an aesthetically clean appearance, though it is more costly and difficult to access for maintenance. Surface mount is more cost-effective and easier to install and maintain but is less durable and more exposed to potential damage and environmental wear. The choice depends on your project's specific needs and constraints. Direct bury is required in locations where there is no concrete foundation or base.
Custom colors can be done for bulk orders. Contact The Safety Source for more details.
1. Install The Bollard
Whether you're using a direct bury bollard or a surface mount bollard, the first step is to install the bollard.
Direct Bury Bollard
After making sure there are no underground utilities in the area and getting permits, direct bury bollards can be installed by coring and digging a hole 2″ wider in diameter than the bollard, and 2″ deeper than the bollard base will sit. Pour concrete to fill the remainder of the hole.
Surface Mount Bollard
Surface mounted bollards are bolted to the concrete through a base plate. The installer marks the positions of the holes in the base plate, and then drills into the concrete surface with a 5/8″ masonry drill bit. The bollard is positioned on top, and bolts are tightened through the base plate which grab into the insert.
2. Slide The Gate Over Top Of The Bollard
Once the bollard is installed and the concrete is dry and secure, if using a direct bury bollard, slide the gate over top of the bollard. To reduce friction from the gate rubbing on the bollard, liberally grease the bollard with lithium grease prior to sliding on the gate. Once the gate is slid over the bollard, it is able to rotate a full 360 degrees.